SAFE CARE® Graffiti, Tar & Gum Remover

Derived from 100% plant-based materials, SC-Graffiti, Tar & Gum
Remover effectively removes most organic and inorganic soils without
harming the cleaning surface. SC-Graffiti, Tar & Gum Remover is a
powerful non-evaporative solvent intended to loosen tough soils such
as tar, chewing gum, permanent marker, ink and graffiti paints. SCGraffiti,
Tar & Gum Remover complies with:

• OSHA 29-CFR Ch. XVII 1910.1200 and 40 CFR Ch. 1, Subparts C & D
• USEPA 600, 4-90, 027 for aquatic toxicity
• USEPA 601 & 602 for VOC testing
• GSA SIN 375-362 & 375-363

SC-Graffiti, Tar & Gum Remover is a powerful replacement for:

• Graffiti, Tar & Gum Remover is a powerful replacement for:
• Xylene
• Toluene, Methyl benzene
• Methyl Ethyl Ketone
• Glycol Ethers, Butyl Cellosolve
• Kerosene, Mineral Oil

Specification

BASIC PROPERTIES:
Appearance: Clear, slightly viscous light yellow liquid
Odor: Distinctive, mild
Water Solubility: Not water soluble
Boiling Point: 144.4ºC (292ºF)
Flash Point: 65.5ºC (150ºF)
Specific Gravity: 0.946
Relative Density: Less than water
pH Range: 6.9
 

Usage Instructions

When removing grease, tar, gum, or similar materials from carpeting
or upholstery fabrics, begin by scraping off any loose material with the
edge of a spatula-like tool. Apply a small amount of SC-Graffiti, Tar
& Gum Remover and allow to dwell for 5 to 10 minutes before
agitating with a nylon brush. For best results, rinse soil and residual
product with an aqueous cleaning solution. Warning: Pre-test small
inconspicuous area before applying. SC-Graffiti, Tar & Gum
Remover should not be left on surfaces for a prolonged period of time
because it will remove most paints or may damage some acrylic
surfaces.